Re: Tools: cutting S&G panels
By:Myrl Tanton
Date: 12/19/2002, 2:58 pm
Date: 12/19/2002, 2:58 pm
In Response To: Tools: cutting S&G panels (Peter)
Make sure you have a plain, cut outside the line, and plain down to it.
I do not think what you use to cut is all that important, but depending on what you use, you will be able to go closer or farther from the line.
Messages In This Thread
- Tools: cutting S&G panels
Peter -- 12/18/2002, 11:32 pm- Re: Tools: cutting S&G panels
Myrl Tanton -- 12/19/2002, 2:58 pm- what to use on inside curves?
mike allen -- 12/19/2002, 5:38 pm- Re: Belt Sander
Rehd -- 12/19/2002, 9:44 pm- Re: what to use on inside curves?
Myrl Tanton -- 12/19/2002, 6:21 pm - Re: what to use on inside curves?
- Re: Belt Sander
- Keep it cheap
Dan Ruff -- 12/19/2002, 1:58 pm- Re: Keep it cheap
warrren -- 12/19/2002, 2:28 pm
- Re: Tools: cutting S&G panels *LINK*
Severne -- 12/19/2002, 12:16 pm- Re: Tools: cutting S&G panels
Peter -- 12/19/2002, 9:17 pm- Re: Tools: cutting S&G panels
warrren -- 12/19/2002, 12:53 pm - Re: Tools: cutting S&G panels
- $5 Stanley retractable utility blade
Tony -- 12/19/2002, 11:51 am- Re: Tools: cutting S&G panels *LINK*
Kurt Loup, Baton Rouge -- 12/19/2002, 8:31 am- Re: Tools: cutting S&G panels
Kurt Maurer -- 12/19/2002, 11:29 am- Re: Tools: cutting S&G panels
Kurt Loup, Baton Rouge -- 12/19/2002, 11:58 am- Re: Tools: cutting S&G panels
Kurt Maurer -- 12/19/2002, 4:13 pm
- Re: Tools: cutting S&G panels
- Re: Tools: cutting S&G panels
- Re: Tools: cutting S&G panels
steve hartmann -- 12/19/2002, 8:05 am- Re: Tools: cutting S&G panels *LINK* *Pic*
Bobby Curtis -- 12/19/2002, 7:53 am- Re: DW 318 jigsaw
Shawn Baker -- 12/19/2002, 10:35 am
- Re: Tools: cutting S&G panels
Paul G. Jacobson -- 12/19/2002, 12:23 am- Re: Tools: cutting S&G panels
Peter -- 12/19/2002, 12:58 am- Re: Tools: cutting S&G panels *Pic*
David Hanson -- 12/19/2002, 10:24 am- Re: Tools: cutting S&G panels
Mark Normand -- 12/19/2002, 9:15 am - Re: Tools: cutting S&G panels
- Re: Tools: cutting S&G panels *Pic*
- what to use on inside curves?
- Re: Tools: cutting S&G panels