S&G: What Plywood for Forms?
By:Gordon Snapp
Date: 11/17/2002, 9:39 pm
Date: 11/17/2002, 9:39 pm
I'm getting ready to start my first stripper - a Guillemot. I'm curious about what to use for the forms. I've seen that 1/2 inch plywood is fine. I have some around, but it's not flat, it's bowed. Most of the 1/2 inch plywood pieces I've bought have been bowed somewhat. Will this affect my boat's fairness? Would there be any problems with using 3/4 inch plywood instead? I don't mind the added expense if it's going to make a better boat.
Messages In This Thread
- S&G: What Plywood for Forms?
Gordon Snapp -- 11/17/2002, 9:39 pm- Re: S&G: What Plywood for Forms? *Pic*
Chip Sandresky -- 11/18/2002, 7:23 pm- Re: S&G: What Plywood for Forms? *LINK* *Pic*
Bobby Curtis -- 11/18/2002, 7:40 am- Re: S&G: What Plywood for Forms?
Rehd -- 11/18/2002, 1:42 am- Re: S&G: What Plywood for Forms? *LINK* *Pic*
Steve Frederick -- 11/17/2002, 10:58 pm- Re: S&G: What Plywood for Forms?
Roger Nuffer -- 11/17/2002, 10:27 pm - Re: S&G: What Plywood for Forms? *LINK* *Pic*
- Re: S&G: What Plywood for Forms? *Pic*