Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: thin kerf saw blade 1" arbor
By:George
Date: 11/10/2007, 4:09 am
In Response To: Re: Strip: thin kerf saw blade 1" arbor (Steve Rasmussen)

: This wouldn't be for a Shopsmith tool - would it? If so, I use the 5/8"
: arbor that I got with a Dado blade kit.

: Steve
It's a 10" sip bench saw, table saw to you guys on the other side of the atlantic.

The drilling out of the arbor is a very precise job, so i'm not considering doing it myself.

Messages In This Thread

Strip: thin kerf saw blade 1" arbor
George -- 11/9/2007, 10:53 am
Re: Strip: thin kerf saw blade 1" arbor
Steve Rasmussen -- 11/9/2007, 8:06 pm
Re: Strip: thin kerf saw blade 1" arbor
George -- 11/10/2007, 4:09 am
saw blade for1" arbor in UK
Paul G. Jacobson -- 11/11/2007, 2:48 am
Re: saw blade for1" arbor in UK
George -- 11/13/2007, 9:53 am
Re: Strip: thin kerf saw blade 1" arbor
Charlie -- 11/9/2007, 11:08 pm
Re: Strip: thin kerf saw blade 1" arbor
Paul G. Jacobson -- 11/9/2007, 6:10 pm