Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Lofting panels
By:Mike Scarborough
Date: 11/24/2004, 11:05 am
In Response To: Re: S&G: Lofting panels (thomas duncan)

If you're plotting out a full sized side panel and have a 3mm error (about 1/8 inch) I'd say that's a tolerance you can live with if you have too. Given the choice, however, I'd make the curve fair and plane off the offending high spots.

Mike

Messages In This Thread

S&G: Lofting panels
Thomas Duncan -- 11/24/2004, 8:40 am
Re: S&G: Lofting panels
Chuck Saloio -- 11/24/2004, 9:42 pm
Re: S&G: Lofting panels *LINK*
gerald -- 11/24/2004, 11:11 am
Re: S&G: Lofting panels
thomas duncan -- 11/24/2004, 2:03 pm
Re: S&G: Lofting panels *LINK*
gerald -- 11/24/2004, 5:40 pm
Re: S&G: Lofting panels
Thomas Duncan -- 11/24/2004, 6:52 pm
Re: S&G: Lofting panels
Mike Scarborough -- 11/24/2004, 8:53 am
Re: S&G: Lofting panels
thomas duncan -- 11/24/2004, 9:39 am
Re: S&G: Lofting panels
Mike Scarborough -- 11/24/2004, 11:05 am