Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

WDITOT
By:Ken Sutherland
Date: 7/26/2001, 3:17 am
In Response To: Re: Hatch Lip seal channel (Paul G. Jacobson)

Thanks Paul,

Why didn't I think of that?
And a smaller piece to do around the curved corners.

Ken

: Use a piece of sand paper wrapped sharply around the side of a small scrap of
: 1/4 inch plywood. Cut the plywood into a rectangle about the size of an
: index card.
: 100 to 150 grit should be fine. The square sides and edges of the plywood
: should follow your molded edge nicely, and be thin enough so you can do
: one side of a channel, and then then slide against the other wall to do
: the other side of the channel.

: Very light pressure is all it takes to remove the foam bits. They should just
: fall apart.

: PGJ

Messages In This Thread

Hatch Lip seal channel
Ken Sutherland -- 7/25/2001, 5:33 am
Re: Hatch Lip seal channel
Paul G. Jacobson -- 7/26/2001, 2:59 am
WDITOT
Ken Sutherland -- 7/26/2001, 3:17 am
I T A S M
Paul G. Jacobson -- 7/27/2001, 3:48 am
Re: How about a wire wheel?
Don Beale -- 7/25/2001, 1:59 pm
Thanks!!!
Ken Sutherland -- 7/26/2001, 1:29 am
Re: Hatch Lip seal channel
Ross Leidy -- 7/25/2001, 12:50 pm
Re: Hatch Lip seal channel
Larry C. -- 7/25/2001, 12:23 pm
Re: Hatch Lip seal channel
Jay Babina -- 7/25/2001, 8:35 am
Re: Hatch Lip seal channel
Jim Kozel -- 7/25/2001, 9:27 am