Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

another idea turned around :)
By:Paul G. Jacobson
Date: 7/23/2001, 3:26 am
In Response To: Bulkheads would be better (Julie Kanarr)

: . . . In an earlier thread a couple months ago,
: someone (Paul Jacobson? was that your idea?) described how to make a
: removable bulkhead that is a smaller plywood core sandwiched between two
: larger diameter pieces of foam with a handle protruding from the middle of
: it, sized so that it will fit snugly into place like a plug.

Actually, it was the other way 'round.: A couple of pieces of plywood sandwiched around a single thick piece of foam. When the bolts holding the plywood together are tightened the foam is forced out at the sides a bit--putting some pressure on the hull to hold the thing in place. Cutting the pieces to a close fit helps the thing work like a plug.

PGJ

Messages In This Thread

Spray Foam for filling in air pockets.
Robert D. Meyer -- 7/20/2001, 6:06 pm
Bulkheads would be better
Julie Kanarr -- 7/21/2001, 7:12 pm
another idea turned around :)
Paul G. Jacobson -- 7/23/2001, 3:26 am
Re: another idea turned around :)
Julie Kanarr -- 7/23/2001, 11:06 am
I decided not to use it after much discussion here *NM*
John Monfoe -- 7/22/2001, 3:51 am
Re: Spray Foam for filling in air pockets.
LeeG -- 7/21/2001, 6:09 pm
Re: Spray Foam for filling in air pockets.
Malcolm Schweizer -- 7/21/2001, 10:07 am
Re: Spray Foam for filling in air pockets.
Chip Sandresky -- 7/21/2001, 4:18 am
Re: Spray Foam for filling in air pockets.
Jack Martin -- 7/21/2001, 10:11 am
Tried it once, won't make the same mistake again
Pete Rudie -- 7/21/2001, 10:06 pm