KBBS Archive 40,000

Re: Bevel?

Posted By: Don Beale
Date: Friday, 2 February 2001, at 1:19 p.m.

In Response To: Re: Oh Great One! (Pete Rudie)

You lost me. The strip dimension is 1/2" on the flat, 1/4"+ on one edge, and 1/4" on the opposite? Then the cove is cut in the + edge and the bead on the smaller edge?

BTW, there is no need
: to plane these guys to make them fit. Rip them with a 3 degree bevel, and
: they fit pretty well. There is a little step of course at the ends, but if
: you rip a little oversize there is enough meat left that insufficient
: thickness is not an issue.

Messages In This Thread

Edge clamps *Pic*
Pete Rudie -- Thursday, 1 February 2001, at 1:15 p.m.

Re: Edge clamps
Ross Leidy -- Thursday, 1 February 2001, at 1:43 p.m.

Re: Oh Great One!
Geo. Cushing -- Friday, 2 February 2001, at 11:31 a.m.

Re: Oh Great One!
Pete Rudie -- Friday, 2 February 2001, at 12:31 p.m.

Re: Bevel?
Don Beale -- Friday, 2 February 2001, at 1:19 p.m.

Re: Bevel?
Pete Rudie -- Friday, 2 February 2001, at 2:12 p.m.

It goes pretty fast, too *Pic*
Pete Rudie -- Friday, 2 February 2001, at 5:05 p.m.

But it's a bit like herding cats... *NM*
Pete Rudie -- Friday, 2 February 2001, at 5:17 p.m.

Erratum: should be "cove but no bead" *NM*
Pete Rudie -- Friday, 2 February 2001, at 5:46 p.m.

Re: Edge clamps
john gray -- Tuesday, 6 February 2001, at 8:07 p.m.

KBBS Archive 40,000 is maintained by Nick Schade - Guillemot Kayaks with WebBBS 5.12.