KBBS Archive 10,000

Sheer strip bevel

Posted By: Steve Lein
Date: Monday, 15 November 1999, at 12:21 a.m.

I started my first stripper kayak yesterday, An 11 foot Little Auk, which will be used as an auxillary for my sailboat. I now have about 1000 feet of cedar and pine stips (and a lot of sawdust). The forms are strung on the strongback and I am ready to start the fun part.

My question is what angle to bevel the sheer. The Little Auk has a sharp angle at the sheer/deck joint at the bow. See figure 5-19 in The Strip-Built Sea Kayak. Nick's general instructions are to bevel the sheer such that it is parallel to the floor. It seems to me that for this sharp angle I should bisect the angle and plane half of it into the sheer strip and half of it into the deck. What is the general practice for stripping sharp angles?

Any suggestions will be greatly appreciated.

Steve Lein

Messages In This Thread

Sheer strip bevel
Steve Lein -- Monday, 15 November 1999, at 12:21 a.m.

Re: Sheer strip bevel
Ross Leidy -- Monday, 15 November 1999, at 9:09 a.m.

Re: Sheer strip bevel
Nick Schade - Guillemot Kayaks -- Monday, 15 November 1999, at 9:25 a.m.

Re: Sheer strip bevel and sheer line
Larry C. -- Monday, 15 November 1999, at 6:21 p.m.

Re: Sheer strip bevel and sheer line
Ross Leidy -- Tuesday, 16 November 1999, at 8:48 a.m.

Re: Sheer strip bevel and sheer line
Nick Schade - Guillemot Kayaks -- Tuesday, 16 November 1999, at 10:29 a.m.

KBBS Archive 10,000 is maintained by Nick Schade - Guillemot Kayaks with WebBBS 5.12.